DJI MATRICE 400 DUAL GIMBAL CONNECTOR

The DJI Matrice 400 Dual Gimbal Connector is a connector that allows two gimbals (payloads) to be mounted under the nose of the DJI Matrice 400 drone, through the E1 and E2 ports of the E-Port V2. The maximum payload is 950 g per gimbal position. It weighs approx. 160 g. The water protection rating depends on the attached payload. It is intended for professional use only, by trained persons. It is not a toy.

Warnings:

• Read the official DJI documentation before mounting and use.
• Install the connector only with the drone powered off.
• Do not exceed the maximum payload of 950 g per gimbal position. Heavier payloads reduce the damper lifespan (from 1,000 to 400 hours) and may affect flight stability.
• Use the connector only with the compatible drone (DJI Matrice 400) and compatible payloads, with original DJI accessories. Check the compatibility of each payload before mounting.
• Before every flight, check that all connections are fixed correctly and securely, especially before flying in bad weather, and that the gimbals move freely.
• Mounting two payloads changes the drone's weight and balance and may affect flight performance and endurance. Fly with caution.
• The protection rating of the assembly is determined by the attached payload (IEC 60529). Do not expose the equipment to water if the payload is not protected.
• Do not open, disassemble or modify the equipment. Do not use it if it is damaged.
• Comply with aviation law in your country.
• Keep out of reach of children.

Manufacturer: SZ DJI Technology Co., Ltd., Shenzhen, China. EU contact: DJI GmbH, Industriestrasse 12, 97618 Niederlauer, Germany.

Matrice 400 Safety Guidelines (PDF)