DJI MATRICE 400 THIRD GIMBAL CONNECTOR

The DJI Matrice 400 Third Gimbal Connector is a connector that allows a third payload (gimbal) to be mounted on the underside of the DJI Matrice 400 drone, through the E3 or E4 port of the E-Port V2. The maximum payload is 3 kg with quick-release mounting and 6 kg with screw-lock fastening. The water protection rating depends on the attached payload. It is intended for professional use only, by trained persons. It is not a toy.

Warnings:

• Read the official DJI documentation before mounting and use.
• Install the connector only with the drone powered off.
• Check the total weight of the gimbal, camera and mounting plates before installation and do not exceed the maximum payload: 3 kg with quick-release, 6 kg with screw-lock fastening only.
• Use the connector only with the compatible drone (DJI Matrice 400) and compatible payloads. Check the compatibility of each payload before mounting.
• The Matrice 400 does not support upward-facing gimbals. All supported positions are on the underside of the drone.
• Before every flight, check that all connections and screws are fixed correctly and securely.
• Mounting a third payload changes the drone's weight and balance and may affect flight performance and endurance. Fly with caution.
• The protection rating of the assembly is determined by the attached payload (IEC 60529). Do not expose the equipment to water if the payload is not protected.
• Do not open, disassemble or modify the equipment. Do not use it if it is damaged.
• Comply with aviation law in your country.
• Do not dispose of the equipment with household waste. Take it to a waste electrical and electronic equipment (WEEE) collection point.
• Keep out of reach of children.

Manufacturer: SZ DJI Technology Co., Ltd., Shenzhen, China. EU contact: DJI GmbH, Industriestrasse 12, 97618 Niederlauer, Germany.

Product Information (PDF)